MULTI POINT FUEL INJECTION

The term MPFI(Multi-point Fuel-Injection ) is used to specify a technology used in Gasoline/petrol Engines. For Diesel Engines, there is a similar technology called CRDI.

MPFI System is a system which uses a small computer (yes, a small computer without keyboard or mouse, its more like a microchip) to control the Car’s Engine. A Petrol car’s engine usually has three or more cylinders or fuel burning zones. So in case of an MPFI engine, there is one fuel –injector installed near each cylinder, that is why they call it Multi-point (more than one points) Fuel Injection.

In plain words, to burn petrol in an Engine to produce power, Petrol has to be mixed with some air, ignited in a cylinder (also called combustion chamber), which produces energy and runs the engine. 

Before MPFI system was discovered, there was a technology called “Carburetor”. Carburetor was one chamber where petrol and air was mixed in a fixed ratio and then sent to cylinders to burn it to produce power. This system is purely a mechanical machine with little or no intelligence. It was not very efficient in burning petrol, it will burn more petrol than needed at times and will produce more pollution. But with the advancement of technology this was about to change.

MPFI emerged an Intelligent way to do what the Carburetor does. In MPFI system, each cylinder has one injector (which makes it multi-point). Each of these Injectors are controlled by one central car computer. This computer is a small micro-processor, which keeps telling each Injector about how much petrol and at what time it needs to inject near the cylinder so that only the required amount of petrol goes into the cylinder at the right moment.

So the working of MPFI is similar to Carburetor, but in an improved way, because now each cylinder is treated independently unlike Carburetor. But one major Key difference is that MPFI is an intelligent system and Carburetor is not. MPFI systems are controlled by a computer which does lots of calculations before deciding what amount of petrol will go into what cylinder at a particular point in time. It makes that decision based on the inputs it reads.

For the Inputs, the microprocessor (or car’s computer) reads a number of sensors. Through these sensors, the microprocessor knows the temperature of the Engine, the Speed of the Engine, it knows the load on the Engine, it knows how hard you have pressed the accelerator, it knows whether the Engine is idling at a traffic signal or it is actually running the car, it knows the air-pressure near the cylinders, it knows the amount of oxygen coming out of the exhaust pipe.

Based on all these inputs from the sensors, the computer in the MPFI system decides what amount of fuel to inject. Thus it makes it fuel efficient as it knows what amount of petrol should go in. To make things more interesting, the system also learns from the drivers driving habits. Modern car’s computers have memory, which will remember your driving style and will behave in a way so that you get the desired power output from engine based on your driving style. For example, if you have a habit of speedy pick-up, car’s computer will remember that and will give you more power at low engine speeds by putting extra petrol, so that you get a good pick-up. It will typically judge this by the amount of pressure you put on accelerator.

So the cars of today are really intelligent, well not as intelligent as drivers but fairly intelligent to keep pollution under control and saving the fuel.